Stretching Aluminum Plate Number

IMPROVING THE EFFICIENCY OF THE STRETCHING PROCESS OF …Erkunden Sie

According to the data from the generated report (Fig. 2), the maximum stretching force applied to the 7075-aluminum alloy plate(s) was 8.1 MN, for which a stretching maximum

Stretch rate and deformation for pre-stretching aluminum alloy

Abstrac Numerical simulation combined with experimental test was carried out to analyze the pre-stretching process of the 7075 aluminum alloy sheet, from which the stress variation

(PDF) Analysis of Quenching and Stretching Processes of

1. Aug. 2014 A mathematical model is developed to calculate the residual stress in stretched aluminum alloy thick plate. It is based on balance of stresses, two-dimensional plasticity

The Influence of Quenching and Stretching Process Conditions of

Abstract. The purpose of this article is to better understand the behaviour of the residual stresses in aluminium alloy plates, to control and minimize them by adjusting the

A modeling of residual stress in stretched aluminum alloy

1. Nov. 2012 A mathematical model is developed to calculate the residual stress in stretched aluminum alloy thick plate. It is based on balance of stresses, two-dimensional plasticity

Numerical Simulation of Quenching-Stretching Process of

1. Dez. 2018 Corpus . Numerical Simulation of Quenching-Stretching Process of Aluminum Alloy Plate and Analysis of Mechanism of Reducing Residual Stresses.

Aluminum Plate Michael R. Hill, University of California,

Through-thickness residual-stress profiles in rolled 7050-T74 aluminum plate were measured before and after stress relief by stretching (-Tx51). Measurement required

Analysis of Quenching and Stretching Processes of Aluminum Alloy

Using the finite element software MSC.MARC, quenching and stretching processes of aluminum alloy plate of size 10000mm×4000mm×50mm are analyzed. As the plate is

Residual stress, stress relief, and inhomogeneity in aluminum plate

4. Jan. 2002 Abstract. Through-thickness residual-stress profiles in rolled 7050-T74 aluminum plate were measured before and after stress relief by stretching (-T 51).